ciscodk分享JN0-532 PDF

Question: 1     

You have entered the following BGP configuration:

-Setvrouter trust-vr bgp 65530

-Setvrouter trust-vr bgp enable

-Setvrouter trust-vr protocol bgp neighbor 1.1.1.250 remote-as 65500

-Setvrouter trust-vr protocol bgp neighbor 1.2.3.250 remote-as 65280

BGP is not working. What two elements are missing from your configuration? (Choose two.)

A. You have not enabled the BGP peers.

B. You have not enabled EBGP multihop.

C. You have not placed the peers in a BGP peer group.

D. You have not enabled BGP on the interfaces connecting to the peers.

Answer: A,D

Question: 2     

Which of the following protocols is required in order to deploy AutoConnect-×××s?

A. PKI

B. OSPF

C. NSRP

D. NHRP

Answer: D

Question: 3     

What are three components that make up a redundant ××× configuration? (Choose three.)

A. master

B. targets

C. monitor

D. backups

E. ××× groups

Answer: B,C,E

Question: 4     

Which ScreenOS CLI command(s) allow(s) for redistribution of type 1-3 LSAs?

A. set ospf export route external

B. set match route-type internal-ospf

C. set redistribute ospf lsa 1

set redistribute ospf lsa 2

set redistribute ospf lsa 3

D. set protocol ospf lsa 1 redistribute

set protocol ospf lsa 2 redistribute

set protocol ospf lsa 3 redistribute

Answer: B

Question: 5     

What must be configured differently for a route-based ××× and a policy-based ×××?

A. proxy-id

B. proposals

C. remote gateway type

D. binding the tunnel interface

Answer: D

本文來源：ciscodk.com