1) 下列操做命令在操做模式下使用,或在配置模式下run show…session
a) Show system software 查看當前軟件版本號併發
b) show system uptime 查看系統啓動時間ide
c) Show chassis haredware 查看硬件板卡及序列號oop
d) show chassis environment 查看硬件板卡當前狀態spa
e) show chassis routing-engine 查看主控板(RE)資源使用及狀態debug
f) show route 查看路由表日誌
g) show arp 查看ARP表orm
h) show log messages 查看系統日誌接口
i) show interface terse 查看全部接口運行狀態資源
j) show interface ge-x/y/z detail 查看接口運行細節信息
k) monitor interface ge-x/y/z 動態統計接口數據包轉發信息
l) monitor traffic interface ge-x/y/z動態報文抓取(Tcpdump,相似ScreenOS snoop命令)
m) show security flow sessionsummary 查看當前防火牆併發會話數
n) show security flow session 查看當前防火牆具體併發會話
o) clear security flow session all 清除當前session
p) show security alg status 檢查全局ALG開啓狀況
q) SRX對應ScreenOS debug flow basic跟蹤報文處理路徑的命令:
2) set security flow traceoptionsflag basic-datapath 開啓SRX基本報文處理Debug
3) set security flow traceoptionsfile filename.log 將輸出信息記錄到指定文件中
4) set security flow traceoptionsfile filename.log size <file-size> 設置該文件大
a) 小,缺省128k
5) set security flow traceoptionspacket-filter filter1 destination-prefix 5.5.5.2
a) 設置報文跟蹤過濾器
6) run file show filename.log 查看該Log輸出信息
a) SRX對應ScreenOS get tech命令,開Case時須要抓取的信息:requestsupport information