t檢驗，T Test (Student’s T-Test)

一、什麼是T test?

t-test：比較數據的均值，告訴你這二者之間是否相同，並給出這種不一樣的顯著性（便是否是由於偶然致使的不一樣）

The t test (also called Student’s T Test) compares two averages (means) and tells you if they
 are different from each other. The t test also tells you how significant the differences are;In 
other words it lets you know if those differences could have happened by chance.

 例子：製藥公司可能想測試一種新的抗癌藥物，看看它是否能提升預期壽命。在實驗中，總有一個對照組(給一組人服用安慰劑，或「糖丸」)。對照組的平均預期壽命爲+5歲，而服用新葯的組的平均預期壽命爲+6歲。看來這種藥可能有效。但這多是一個巧合。爲了驗證這一點，研究人員將使用Student’s t-test來發現結果是否能夠在整我的羣中重複

Student’s T-tests can be used in real life to compare means. For example, a drug company may 
want to test a new cancer drug to find out if it improves life expectancy. In an experiment, 
there’s always a control group (a group who are given a placebo, or 「sugar pill」). The control
 group may show an average life expectancy of +5 years, while the group taking the new drug 
might have a life expectancy of +6 years. It would seem that the drug might work. But it could 
be due to a fluke. To test this, researchers would use a Student’s t-test to find out if the 
results are repeatable for an entire population.

 二、The T Score.

T Score：是兩組之間的差別與組內差別的比值。t值越大，組間差別越大。t值越小，組間的類似性越大。t得分爲3表示兩個組之間的差別是它們內部差別的三倍。當您運行t測試時，t值越大，結果越有多是可重複的

The t score is a ratio between the difference between two groups and the difference within the
 groups. The larger the t score, the more difference there is between groups. The smaller the t
 score, the more similarity there is between groups. A t score of 3 means that the groups are 
three times as different from each other as they are within each other. When you run a t test, 
the bigger the t-value, the more likely it is that the results are repeatable

• A large t-score tells you that the groups are different.
• A small t-score tells you that the groups are similar

 三、T-Values and P-values

P-values：「足夠大」有多大?每一個t值都有一個p值。p值是樣本數據的結果偶然發生的機率。p值從0%到100%。它們一般寫成小數。例如，5%的p值是0.05。低p值是好的;它們代表您的數據不是偶然產生的。例如，p值爲0.01意味着實驗結果碰巧發生的機率只有1%。在大多數狀況下，p值爲0.05(5%)表示數據有效

How big is 「big enough」? Every t-value has a p-value to go with it. A p-value is the probability
 that the results from your sample data occurred by chance. P-values are from 0% to 100%.
 They are usually written as a decimal. For example, a p value of 5% is 0.05. Low p-values are
 good; They indicate your data did not occur by chance. For example, a p-value of .01 means
 there is only a 1% probability that the results from an experiment happened by chance. In
 most cases, a p-value of 0.05 (5%) is accepted to mean the data is valid.

 四、main types of t-test

An Independent Samples t-test((also called the unpaired samples t test)) compares the means for two groups.
A Paired sample t-test(also called a correlated pairs t-test, a paired samples t test or dependent
samples t test) compares means from the same group at different times (say, one year apart).
A One sample t-test tests the mean of a single group against a known mean.

 4.一、 Independent Samples t-test

獨立樣本t檢驗(又稱未配對樣本t檢驗)是t檢驗最多見的形式。它幫助您比較兩組數據的方法。例如，你能夠作一個t測試，看看男性和女性的平均測試成績是否不一樣;測試回答了這個問題:「這些差別多是隨機產生的嗎?」

前提是須要三個假設：獨立假設、正態分佈假設、方差同質性假設

 Assumption of Independence: you need two independent, categorical groups that represent
 your independent variable. In the above example of test scores 「males」 or 「females」 would be
 your independent variable.
  Assumption of normality: the dependent variable should be approximately normally
 distributed. The dependent variable should also be measured on a continuous scale. In the 
above example on average test scores, the 「test score」 would be the dependent variable.
 Assumption of Homogeneity of Variance: The variances of the dependent variable should be equal.

手動計算：Calculating an Independent Samples T Test By hand（https://www.statisticshowto.datasciencecentral.com/independent-samples-t-test/）

Sample question: Calculate an independent samples t test for the following data sets:

Data set A: 1,2,2,3,3,4,4,5,5,6
Data set B: 1,2,4,5,5,5,6,6,7,9

 Step 1: Sum the two groups(求各自樣品的總和):

A: 1 + 2 + 2 + 3 + 3 + 4 + 4 + 5 + 5 + 6 = 35
B: 1 + 2 + 4 + 5 + 5 + 5 + 6 + 6 + 7 + 9 = 50

 Step 2: Square the sums from Step 1(求各自樣品總和的平方):

35 * 35= 1225
49 * 49 = 2401

 Step 3: Calculate the means for the two groups:

A: (1 + 2 + 2 + 3 + 3 + 4 + 4 + 5 + 5 + 6)/10 = 35/10 = 3.5
B: (1 + 2 + 4 + 5 + 5 + 5 + 6 + 6 + 7 + 9) = 50/10 = 5

Step 4: Square the individual scores and then add them up:
A: 1¹ + 2² + 2² + 3³ + 3³ + 4⁴ + 4⁴ + 5⁵ + 5⁵ + 6⁶ = 145
B: 1² + 2² + 4⁴ + 5⁵ + 5⁵ + 5⁵ + 6⁶ + 6⁶ + 7⁷ + 9⁹ = 298

Step 5: Find the Degrees of freedom

(n_A-1 + n_B-1) =（10-1）+（10-1）= 18

Step 6: Insert your numbers into the following formula and solve:

 

帶入求值結果爲-1.69

(ΣA)²: Sum of data set A, squared (Step 2).
(ΣB)²: Sum of data set B, squared (Step 2).
μ_A: Mean of data set A (Step 3)
μ_B: Mean of data set B (Step 3)
ΣA²: Sum of the squares of data set A (Step 4)
ΣB²: Sum of the squares of data set B (Step 4)
n^A: Number of items in data set A
n^B: Number of items in data set B

Step 7: Look up your degrees of freedom (Step 5) in the t-table(https://www.statisticshowto.datasciencecentral.com/tables/t-distribution-table/).

If you don’t know what your alpha level is, use 5% (0.05).18 degrees of freedom at an alpha level of 0.05 = 2.10.

Step 8: Compare your calculated value (Step 6) to your table value (Step 7).

The calculated value of -1.79 is less than the cutoff of 2.10 from the table. Therefore p >0 .05. 
As the p-value is greater than the alpha level, we cannot conclude that there is a difference 
between means.

  4.二、 A paired t test

 配對t測試(也稱爲相關配對t測試、配對樣本t測試或依賴樣本t測試)是在依賴樣本上運行t測試的地方。依賴的樣本本質上是相連的—它們是同一我的或事物的測試。例如訓練先後對同一我的進行兩次測試；同一我的使用不一樣的儀器進行兩次血壓測量。

 手動計算paired t test：https://www.statisticshowto.datasciencecentral.com/probability-and-statistics/t-test/

小明先後兩次考試：

score1： 三、 三、 三、十二、1五、1六、1七、1九、2三、2四、32
score2: 20、1三、1三、20、2九、3二、2三、20、2五、1五、30

 Step 1: Subtract each Y score from each X score(每一個Y分數減去每一個X分數).

步驟2:將步驟1中的全部值相加

 

步驟3:將與步驟1的差別平方

步驟4:將全部與步驟3不一樣的平方相加

 

步驟5:用如下公式計算t-score:

ΣD: Sum of the differences (Sum of X-Y from Step 2)
ΣD²: Sum of the squared differences (from Step 4)
(ΣD)²: Sum of the differences (from Step 2), squared

Step 6: Subtract 1 from the sample size to get the degrees of freedom（計算自由度）.

We have 11 items, so 11-1 = 10.

 Step 7: Find the p-value in the t-table, using the degrees of freedom in Step 6.

If you don’t have a specified alpha level, use 0.05 (5%). For this sample problem, with df=10, the t-value is 2.228.

 步驟8:比較步驟7(2.228)到計算t值(-2.74)的t表值(table表)。

在alpha水平爲0.05時，計算的t值大於表值。p值小於alpha水平:p <0.05。咱們能夠拒絕均值之間沒有差別的零假設。

 五、參考網址

https://www.statisticshowto.datasciencecentral.com/probability-and-statistics/t-test/

https://www.statisticshowto.datasciencecentral.com/tables/t-distribution-table/