vmax劃盤

先說幾個概念

initiator group（IG）：小機的wwn號 group，map給那些小雞

port group（PG）：  存儲前端端口集合，從存儲的那些前端口出去

storage group(PG)：要map的lun的group  map給小機那些lun

masking view ：集合以上3個group，就能夠把lun map給小機

1.Create Initiators and Initiator Groups

方法1：Unisphere for VMAX

先到陣列的管理機裏面，打開Unisphere for VMAX web 站點

https://localhost:8443/univmax  

點擊Hosts > Create New Host

選擇要配置的vmax的Symmetrix ID，輸入一個Host name 如： esx01

在Initiator/Initiator Group 處輸入或者選擇主機的pwwn號，通常狀況下每臺主機最少2個，Show Advanced 而後 Set Initiator Flags

選擇:

Common_Serial_Number(C)  Override and Enable

SPC2_Protocol_Version(SPC2) Override and Enable

Consistent LUNs

點擊 Finish

方法2：cli方式

首先爲initiator group須要的pwwn號建立一個txt文件

如txt文件名字：initiatorX.txt 格式以下

WWN:20000025B502xxxx

WWN:20000025B502xxxx

建立完成後輸入以下命令：

symaccess -sid create -name -type inititator -file

驗證:

symaccess -sid list | findstr /i "some unique characters in initiator name"

The findstr /i is optional and only to narrow the search results

2.Creating a Port Group

如 ESXi boot Port Group:

Hosts > Port Groups > Create

Port Group Name   - set to logical name 如： ESX01_BOOT

Add the same FA ports that you've zoned the host to on the switch, typically at least 4 ports

點擊 OK

CLI:

symaccess -sid create -name -type port -dirports

Where Director FA is in format 11F and Port is either port 0 or port 1

3.Creating a Storage Group

如：ESXi Boot Storage:

Storage Group Name - set to logical name i.e. ESX01_BOOT

Manual Selection and click Next

Select the Filter icon and the Volume Identifier menu then click Show Advanced

Enter the Volume Identifier Name and hit Enter key i.e. ESX01_BOOT added same identifier when creating the volume

Click Add to Group to add the volume

Click Finish

From CLI:

symaccess -sid create -name -type storage -devs  

4.Creating a Masking View

如 ESXi boot masking view

Go to Hosts > Masking Views > Create

Enter a name 如： ESX01_BOOT

Select the Initiator Group - hopefully similar name

Select the Port Group - again, hopefully a similar name

Select the Storage Group - """""""

點擊 Set dynamic LUNs 確保他設置爲0 ，而後點擊cancel

點擊 OK

CLI:

symaccess -sid create view -name -storgrp -portgrp -initgrp

驗證:

symaccess -sid show view