實驗過程：
ide
第一步：在R1上進行配置
R1(config)#int e0/1
R1(config-if)#no sh
R1(config-if)#exi
R1(config)#int e0/1.1
R1(config-subif)#en dot1Q 100（vlan id）
R1(config-subif)#ip add 192.168.1.254 255.255.255.0
R1(config-subif)#exit
R1(config)#int e0/1.2
R1(config-subif)#en dot1Q 200
R1(config-subif)#ip add 172.16.1.254 255.255.255.0
R1(config-subif)#exi
R1(config)#end
第二步：在sw1上進行配置
測試
sw1(config)#int f2/1
sw1(config-if)#sw trunk encapsulation dot1q
sw1(config-if)#switchport mode trunk
sw1(config-if)#end
blog
sw1#vlan da
sw1#vlan database
sw1(vlan)#vlan 100 name pc1:192
VLAN 100 added:
Name: pc1:192
sw1(vlan)#vlan 200 name pc2:172
VLAN 200 added:
Name: pc2:172
ip
sw1(config)#int f2/2
sw1(config-if)#sw mo ac
sw1(config-if)#sw acc vlan 100
sw1(config-if)#int f2/3
sw1(config-if)#sw mo acc
sw1(config-if)#sw acc vlan 200
sw1(config-if)#exit
第三步：在R3和R2上配置各類參數
路由
R2(config)#no ip routing
R2(config)#int e0/1
R2(config-if)#ip add 192.168.1.1 255.255.255.0
R2(config-if)#no sh
R2(config-if)#exi
R2(config)#ip default-gateway 192.168.1.254
it
R3(config)#no ip routing
R3(config)#int e0/1
R3(config-if)#ip add 172.16.1.1 255.255.255.0
R3(config-if)#no sh
R3(config)#ip default-gateway 172.16.1.254
第四步：測試
R2#ping 172.16.1.1
io
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 60/75/112 ms
class
R3#ping 192.168.1.1配置
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 56/94/128 ms
im